Can I paint a cordless drill?
Monday, September 12th, 2011 at
10:51 am
I have a ugly looking drill and was wondering if I spray painted over it will the paint rub off when I'm using it? Would a clear coat help the issue?
Tagged with: clear coat
If you rough up the plastic with sandpaper, the paint will coat and stick better. Yes, it will wear off where it is handled most, but will look good for awhile. Yes, clear coat will help the paint last longer. It’s best if you sand the paint (read the directions on the clear coat for grit of sandpaper) before the first coat and between coats. Ask at your local hardware store for what kind of paint they have that is rated for plastic. It usually says on the can, so you can get it at a big store where nobody helps you ;)
This is fine for a cordless drill which works on batteries. Do NOT do this to a plug-in drill as the paint might make it more conductive and violate the integrity of the double-insulated, UL listed, case. It would then be a dangerous electrical hazard.
You gotta ask yourself " is this worth the effort? or am I insane?.
Ugly looking but working fine and the motor is in tiptop condition, your decision to repaint is very much commended in the sustainable practice. Any repaint done at home will definitely no match to the factory paint.. Good paint for plastic body will last some time…
You need to use a paint that is compatible with the type of plastic your drill is made from. Check with your local paint store or the paint section of your local hardware store.
The drill must be clean and free from oil and grease. You also need to block any moving parts from the paint, such as the chuck and the trigger. Use painter’s tape. Also block any vent holes to keep overspray from gumming up you motor. You may be sorry if you don’t.
A clear coat will make the paint finish more resistant to wear. Eventually though, all paints will wear away with enough handling and abrasion.